Press the switch to lock the passenger window switches.
Use this switch to prevent children from accidentally opening or closing a passenger window.
The power windows can be operated when
The engine switch is in the “on” position.
The engine switch is in ignition on mode.
Operating the power windows after turning the engine off
The power windows can be operated for approximately 45 seconds after the engine switch is turned to the “acc” or “lock” position. They cannot, however, be operated once either front door is opened.
The power windows can be operated for approximately 45 seconds after the engine switch is turned to accessory mode or turned off. They cannot, however, be operated once either front door is opened.
Jam protection function (if equipped for driver’s window)
If an object becomes caught between the window and the window frame, window travel is stopped and the window is opened slightly.
When the power window does not close normally
If the jam protection function is operating abnormally and a window cannot be closed, perform the following operations using the power window switch on the driver’s door.
If you release the switch while the window is moving, start again from the beginning.
If the window continues to close but then re-open slightly even after performing the above procedure correctly, have the vehicle inspected by your toyota dealer.
Caution
Observe the following precautions.
Failure to do so may result in death or serious injury.
Closing the windows
Jam protection function (if equipped for driver’s window)
Circuit inspection
A description of the main areas of each circuit inspection
is below.
Item
Description
description
The major role, operation of the circuit and its component parts are
explained.
Dtc no., Dtc detection condition, trouble area
Indicates the diagnostic trouble cod ...
Installation
Install fuel filler opening lid lock retainer
Install the lock retainer and turn it counterclockwise
as shown in the illustration.
Install fuel filler opening lid lock retainer
Install the cable and turn it clockwise as shown in
the illustration.
Install the fuel l ...
Compressor circuit
Description
When the a/c switch is turned on, the magnetic clutch on signal is sent from
the air conditioning
amplifier. Then the mg clt relay turns on to operate the magnetic clutch.
Wiring diagram
Inspection procedure
Inspection procedure
Perform active test by intelligent tester (a ...