Operating the wiper lever
The wiper operation is selected by moving the lever as follows.
If equipped, wiper intervals can be adjusted when intermittent operation is selected.
The wipers will automatically operate a couple of times after the washer squirts.
For Canada
If equipped, wiper intervals can be adjusted when intermittent operation is selected.
The wipers will automatically operate a couple of times after the washer squirts.
The windshield wipers and washer can be operated when
The engine switch is in the “on” position.
The engine switch is in ignition on mode.
If no windshield washer fluid sprays
Check that the washer nozzles are not blocked if there is washer fluid in the washer fluid reservoir.
Caution
Caution regarding the use of washer fluid
When it is cold, do not use the washer fluid until the windshield becomes warm. The fluid may freeze on the windshield and cause low visibility. This may lead to an accident, resulting in death or serious injury.
Notice
When the windshield is dry
Do not use the wipers, as they may damage the windshield.
When the washer fluid tank is empty
Do not operate the switch continually as the washer fluid pump may overheat.
When a nozzle becomes blocked
In this case, contact your toyota dealer.
Do not try to clear it with a pin or other object. The nozzle will be damaged.
To prevent battery discharge
Do not leave the wipers on longer than necessary when the engine is off.
Communication
Description
The skid control ecu sends signals such as cruise control cancel demand
signals and brake operation
demand from ecm response signals to the ecm when the cruise control system is in
operation.
Inspection procedure
Hint:
This circuit uses can communication. Therefore, if t ...
Brake pedal load sensing switch
On-vehicle inspection
Inspect brake pedal load sensing switch
Hint:
Do not remove the brake pedal load sensing switch
from the brake pedal support.
When there is a malfunction in the brake pedal load
sensing switch, replace the brake pedal support.
Disconnect the brake pedal l ...
Inspection
Inspect front seat outer belt assembly
Notice:
Do not disassemble the retractor.
Before installing the outer belt, check the elr.
When the inclination of the retractor is 15Рor
less, check that the belt can be pulled from the
retractor. When the inclination of the retractor ...