Toyota RAV4 (XA40) 2013-2018 Owners Manual: Before driving
Floor mat
Use only floor mats designed specifically for vehicles of the same model and model year as your vehicle. Fix them securely in place onto the carpet.
- Insert the retaining hooks (clips)
into the floor mat eyelets.
- Turn the upper knob of each
retaining hook (clip) to secure
the floor mats in place.
*: Always align the 
marks.
The shape of the retaining hooks (clips) may differ from that shown in the illustration.
Caution
Observe the following precautions.
Failure to do so may cause the driver’s floor mat to slip, possibly interfering with the pedals while driving. An unexpectedly high speed may result or it may become difficult to stop the vehicle, leading to an accident, or leading to death or a serious injury.
When installing the driver’s floor mat
- Do not use floor mats designed for other models or different model year vehicles, even if they are toyota genuine floor mats.
- Only use floor mats designed for the driver’s seat.
- Always install the floor mat securely using the retaining hooks (clips) provided.
- Do not use two or more floor mats on top of each other.
- Do not place the floor mat bottom-side up or upside-down.
Before driving
- Check that the floor mat is securely
fixed in the correct place with all the
provided retaining hooks (clips). Be
especially careful to perform this check
after cleaning the floor.
- With the engine stopped and the shift lever in p, fully depress each pedal to the floor to make sure it does not interfere with the floor mat.
For safe use
...
For safety drive
For safe driving, adjust the seat and mirror to an appropriate
position before driving. ...
Other materials:
On-vehicle inspection
Check ignition coil assembly and perform spark test
Notice:
in this section, the terms "cold" and "hot" refer to
the temperature of the coils. "Cold" means
approximately -10 to 50°c (14 to 122°f). "Hot" means
approximately 50 to 100°c (122 to 212 ...
Installation
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
When replacing the clip, heat the clip and body using a
heat light.
Standard heating temperature
Notice:
Do not heat the clip and vehicle body excessively.
Replace roof dri ...
Adjusting the mirrors
Make sure that you can see backward clearly by adjusting the inside
and outside rear view mirrors properly.
Caution
Observe the following precautions.
Failure to do so may result in death or serious injury.
Do not adjust the position of the driver’s seat while driving.
Doing so could ...
