Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Front pillar upper cover

Components

Toyota RAV4. Components


Installation
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Install rear door belt moulding assembly lh Attach the claws to ins ...

Removal
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Remove front pillar cover sub-assembly upper lh Using a moulding remover, ...

Other materials:

Removal
Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove no. 1 Engine under cover Remove front fender apron rh Remove radia ...

Installation
Caution: Be sure to read the precautionary notices concerning the srs airbag system before servicing it (see page rs-1). Install roof side rail bracket lh Install the bracket with the 2 bolts. Torque: 14 n*m (143 kgf*cm, 10 ft.*Lbf) Install curtain shield airbag assembly lh ...

Downhill assist control operation switch (test mode dtc)
Description The downhill assist control switch is connected to the skid control ecu in the abs and traction actuator. Dtc c1379/74 can be detected when the downhill assist control switch sends the downhill assist control switch signal or test mode ends. Dtc c1379/74 is output only in t ...

В© 2011-2026 Copyright www.trav4.net