Toyota RAV4 (XA40) 2013-2018 Service Manual: Lumbar support adjuster assembly
Inspection
- Inspect lumbar support adjuster assembl
- Check operation of the lumbar support adjuster.
- Check if the lumbar support adjuster moves smoothly when the battery is connected to the lumbar support adjuster motor connector terminals.
Ok
If the result is not as specified, replace the lumbar support adjuster assembly.
Front power seat lumbar switch
Inspection
Inspect front power seat lumbar switch lh
Measure the resistance between the terminals when
the switch is operated.
Standard resistance
If the result is not as specified ...
Seat heater switch
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent ai ...
Other materials:
Precaution
Handling precautions for srs airbag
system
Handling precautions for srs airbag system (see
page rs-1).
Handling precautions for steering
column
When handling the steering column assembly.
Avoid any impact to the steering column
assembly, especially to the motor or ...
Luggage room light
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove back door center garnish (see page
ed-59)
...
General information
A large number of ecu controlled systems are used in the
rav4. In general, ecu controlled systems are considered to
be very intricate, requiring a high level of technical knowledge
to troubleshoot. However, most problem checking procedures
only involve inspecting the ecu controlled system's circ ...
