Toyota RAV4 (XA40) 2013-2018 Service Manual: Removal
- Remove radiator grille sub-assembly
- Remove the 4 bolts and 4 nuts.
- Detach the 6 claws and remove the radiator grille.
- Remove no. 1 Radiator grille lower
- Detach the 16 claws and remove the radiator grille.
- Remove no. 2 Radiator grille lower
- Detach the 16 claws and remove the radiator grille.
Ebxotdeyrior radiator grille (for 2gr-fe)
Components
...
Disassembly
Hint:
When removing the ornament plate and emblem, heat the
radiator grille, ornament plate and emblem using a heat light.
Standard heating temperature
Notice:
Do not heat the radiator grille, ...
Other materials:
Blower resistor
On-vehicle inspection
Inspect blower motor control
Measure the resistance of the blower resistor.
Standard resistance
If the resistance is not as specified, replace the
blower motor control. ...
Fastening and releasing
the seat belt
To fasten the seat belt, push
the plate into the buckle until a click sound is heard.
To release the seat belt,
press the release button A.
â– Emergency locking retractor
(ELR)
The retractor will lock the belt during
a sudden stop or on impact. It may
also lock if you lean forward too
quickly ...
Rear coil spring
Components
Removal
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Remove rear wheel
Remove skid control sensor wire (for 2wd)
(see page bc-198)
Remove rear speed sensor lh (for 4wd) (see
page bc-205)
Disconnect ...
