Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Removal

Hint:

  1. Remove roof rack support sub-assembly center

Toyota RAV4. Remove roof rack support sub-assembly center


  1. Remove the 4 roof carrier caps and roof rack support center.
  1. Remove roof rack bar front

Toyota RAV4. Remove roof rack bar front


  1. Remove the 4 screws and roof rack bar.
  1. Remove roof rack leg cover front lh

Toyota RAV4. Remove roof rack leg cover front lh


  1. Remove the leg cover.
  1. Using a screwdriver, detach the 4 claws.

Hint:

Tape the screwdriver tip before use.

  1. Detach the rib from the bar.
  1. Detach the rib from the bar.

Toyota RAV4. Detach the rib from the bar.


  1. Remove the leg cover.
  1. Using a screwdriver, detach the 4 claws.

Hint:

Tape the screwdriver tip before use.

  1. Detach the rib from the bar.
  1. Remove roof rack assembly lh

Toyota RAV4. Remove roof rack assembly lh


Remove the 4 bolts and the roof rack.

  1. Remove roof rack leg front lh

  1. Remove the 2 screws and roof rack leg front.
  2. Remove the leg cushion front.
  1. Remove roof rack leg rear lh

  1. Remove the 2 screws and roof rack leg rear.
  2. Remove the leg cushion rear.
Components
...

Installation
Replace roof carrier seal Remove the seals. Install new seals as shown in the illustration. Install roof rack leg front lh Install the leg cushion front. Install the roof ...

Other materials:

Settings display
Vehicle settings and the content displayed on the screen can be changed by using the meter control switches. â–  Setting procedure 1. Operate or of the meter control switches and select . 2. Operate or of the meter control switches and select the desired item. If the function is turned on and ...

Shift solenoid "d" performance (shift solenoid valve s4)
System description The ecm uses signals from the output shaft speed sensor and input speed sensor to detect the actual gear position (1st, 2nd, 3rd or o/d gear). Then the ecm compares the actual gear with the shift schedule in the ecm memory to detect mechanical problems of the shift s ...

Operation check
Illuminated entry system operation check   The illuminated entry system controls the following lights: Ignition key cylinder light*1 or transponder key amplifier*2 Foot light Map light and room light Hint: *1: W/o engine immobiliser system *2: W/ engine immobiliser ...

© 2011-2026 Copyright www.trav4.net