Toyota RAV4 (XA40) 2013-2018 Service Manual: 2az-fe exhaust

Fuel tank cap

Inspection Inspect fuel tank cap assembly Visually check that the cap and gasket are not deformed or damaged. If the result is not as specified, replace the cap assembly or gaske ...

Exhaust pipe

Installation Install front exhaust pipe assembly Using a vernier caliper, measure the free length of the compression spring. Minimum length: 41.5 Mm (1.634 In.) If the length is l ...

Other materials:

Throttle / pedal position sensor / switch "d" circuit range / performance
Description Hint: Refer to dtc p2120 (see page es-282). Monitor description When the difference between the output voltages of vpa and vpa2 deviates from the standard, the ecm determines that the accelerator pedal position (app) sensor is malfunctioning. The ecm turns on the mil and th ...

Washer motor
Components Removal Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove washer inlet sub-assembly Remove th ...

Turning the high beam on/off manually
Switching to low beam Pull the lever to original position. Switching to high beam Turn the light switch to position. The automatic high beam indicator will turn off and the high beam indicator will turn on. The automatic high beam can be operated when Vehicles without a smart ke ...