Toyota RAV4 (XA40) 2013-2018 Service Manual: Abbreviations used in manual

Terms

...

Glossary of sae and toyota terms

This glossary lists all sae-j1930 terms and abbreviations used in this manual in compliance with sae recommendations, as well as their toyota equivalents. ...

Other materials:

Installation (2005/11-2006/01)
Install front drive shaft assembly lh Coat the spline of the inboard joint shaft with gear oil. Using a brass bar and hammer, align the shaft splines in the drive shaft. Notice: Set the snap ring with the opening side facing downwards. Be careful not to damage the oil s ...

Test mode procedure
Hint: By switching the skid control ecu from normal mode to test mode, abnormality detection sensitivity is enhanced and troubleshooting can be conducted efficiently. Perform a sensor check in test mode after the speed sensor or sensor rotor has been repaired or replaced. If the igniti ...

Inspection
Inspect rear stabilizer link assembly lh As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn. ...