Toyota RAV4 (XA40) 2013-2018 Owners Manual: Air conditioning filter
The air conditioning filter must be changed regularly to maintain air conditioning efficiency.
Removal method
- Vehicles without a smart key system: turn the engine switch to the
“lock” position.
Vehicles with a smart key system: turn the engine switch off.
- Open the glove box. Slide off the damper.
- Push in each side of the glove box to disconnect the claws.
- Remove the filter cover.
- Remove the air conditioning filter
and replace it with a new
one.
The
marks shown on the filter
should be pointing up.
Changing interval
Inspect and replace the air conditioning filter according to the maintenance schedule. In dusty areas or areas with heavy traffic flow, early replacement may be required. (For scheduled maintenance information, please refer to the “owner’s manual supplement” or “scheduled maintenance”.)
If air flow from the vents decreases dramatically
The filter may be clogged. Check the filter and replace if necessary.
Notice
When using the air conditioning system
Make sure that a filter is always installed.
Using the air conditioning system without a filter may cause damage to the system.
Wheels
If a wheel is bent, cracked or heavily corroded, it should be
replaced. Otherwise, the tire may separate from the wheel or
cause a loss of handling control.
Wheel selection
When replacing wheels, ...
Wireless remote
control/electronic
key battery
Replace the battery with a new one if it is depleted.
You will need the following items:
Flathead screwdriver
Small flathead screwdriver
Lithium battery cr2016 (vehicles without a smart key s ...
Other materials:
Parking Support Brake
function (rear-crossing
vehicles)
If a rear radar sensor detects a vehicle approaching from the
right or left at the rear of the vehicle and the system determines
that the possibility of a collision is high, this function
will perform brake control to reduce the likelihood of an
impact with the approaching vehicle.
Examples of funct ...
Installation
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Install rear stabilizer bush
Install the 2 bushes.
Hint:
Install each bush to the outer side of the bush
stopper on each stabilizer bar.
Install each bush with ...
How to proceed with troubleshooting
Hint:
Use these procedures to troubleshoot the lighting system.
*: Use the intelligent tester.
Vehicle brought to workshop
Inspect battery voltage
Standard voltage:
11 to 14 v
If the voltage is below 11 v, recharge or replace the battery
before proceeding.
Refer to pr ...
