Front (vehicles with slide function)
Slide the console box lid forward or backward as needed.
Pull the lid forward by holding the front of the lid.

Rear
Fold down the armrest for use.

Notice
To prevent damage to the armrest
Do not apply too much load on the armrest.
Seat heaters
Coat hooksAir conditioning control panel does not operate
Description
This circuit consists of the air conditioning control and the air
conditioning amplifier. When the air
conditioning control is operated, signals are transmitted to the air
conditioning amplifier through the lin
communication system.
If the lin communication system malfunctions, ...
Installation
Install crankshaft position sensor
Notice:
Make sure that the o-ring is not cracked or jammed
when installing it.
Apply a light coat of engine oil to the o-ring of the
sensor.
Install the sensor with the bolt.
Torque: 9.0 N*m (90 kgf*cm, 80 in.*Lbf)
Install the wire ha ...
Switch failure
Description
This dtc is output when the sliding roof drive gear (sliding roof ecu)
detects that the slide open or
tilt up switch in the overhead junction block is stuck for 30 seconds or more.
Wiring diagram
Refer to dtc b2341 (see page rf-11).
Inspection procedure
Read value of i ...