Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Footwell light

On-vehicle inspection

Toyota RAV4. Footwell light


  1. Inspect footwell light

  1. Connect the battery's positive (+) lead to terminal 2 and the negative (-) lead to terminal 1, then check that the light comes on.

Ok: light comes on.

If the result is not as specified, replace the light.

Front console illumination
On-vehicle inspection Inspect front console illumination Connect the battery's positive (+) lead to terminal 1 and the negative (-) lead to terminal 2, then check that the light come ...

Headlight dimmer switch
Precaution Precaution for vehicle with srs Some procedures in this section may affect the supplemental restraint system (srs). Prior to performing the procedures, read the srs section's ...

Other materials:

Front passenger side seat belt warning light malfunction
Description When the ignition switch is on, the center airbag sensor transmits front seat inner belt status signals to the combination meter through the can bus line. If the front passenger seat belt is not fastened, the heater control panel (automatic a/c) or clock (manual a/c) blinks the fr ...

Inspection
Inspect engine coolant temperature sensor Measure the resistance of the sensor. Standard resistance Notice: If checking the sensor in water, be careful not to allow water to contact the terminals. After checking, wipe the water off the sensor. If the result is not as specified, ...

Removal
Discharge fuel system pressure (see page fu-9) Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove hood sub-assembly ( ...

В© 2011-2026 Copyright www.trav4.net