Toyota RAV4 (XA40) 2013-2018 Service Manual: Front seat assembly (for manual seat)

Seat heater system

Parts location System diagram Problem symptoms table Hint: Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in orde ...

Removal

Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Disconnect cable from negative battery terminal Caution: Wait at least 90 ...

Other materials:

Test mode procedure
Hint: By switching the skid control ecu from normal mode to test mode, abnormality detection sensitivity is enhanced and troubleshooting can be conducted efficiently. Perform a sensor check in test mode after the speed sensor or sensor rotor has been repaired or replaced. If the igniti ...

Installation
Install no. 2 Chain sub-assembly Set the crankshaft key in the left horizontal position. Turn the cutout of the drive shaft so that it faces upward. Align the yellow mark links with the timing marks of each gear as shown in the illustration. Install the sprockets onto ...

Data list / active test (2006/01- )
Read data list Hint: Using the intelligent tester's data list allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the data list early in troubleshooting is one way to save time. Connect the intelligent tester (with can vim) to the ...