Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: How to proceed with troubleshooting

Toyota RAV4 (XA40) 2013-2018 Service Manual / Lighting / Lighting system / How to proceed with troubleshooting

Hint:

  1. Vehicle brought to workshop


  1. Inspect battery voltage

Standard voltage: 11 to 14 v

If the voltage is below 11 v, recharge or replace the battery before proceeding.


  1. Refer to problem symptoms table

Toyota RAV4. Refer to problem symptoms table




  1. Overall analysis and troubleshooting*

  1. Data list / active test (see page li-22)
  2. Terminals of ecu (see page li-19)


  1. Adjust, repair or replace


  1. Confirmation test


End

System description
Lighting system Illumination control system (illuminated entry system): When the doors are unlocked by a key or transmitter operation, or when a door is opened or closed, the illuminat ...

Operation check
Illuminated entry system operation check   The illuminated entry system controls the following lights: Ignition key cylinder light*1 or transponder key amplifier*2 Foot ligh ...

Other materials:

Cooling fan motor
On-vehicle inspection Inspect no. 1 Cooling fan motor Disconnect the no. 1 Fan connector. Connect the battery and ammeter to the no. 1 Fan motor connector. Check that the no. 1 Fan rotates smoothly, and then check the reading on the ammeter. Standard amperage ...

Ig1 relay
On-vehicle inspection Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove ig1 relay Remove the ig1 relay from the i ...

Driving the vehicle
The following procedures should be observed to ensure safe driving: Starting the engine Driving With the brake pedal depressed, shift the shift lever to d. Release the parking brake. Gradually release the brake pedal and gently depress the accelerator pedal to accelerate the vehicle. ...

В© 2011-2026 Copyright www.trav4.net