Lighting
Parts locationCan bus line
Description
When any dtc for the can communication system is output, first measure the
resistance between the
terminals of the dlc3 to specify the trouble area, and check that there is not a
short in the can main wire,
between the main wire, to +b, or to gnd.
Wiring diagram
Inspecti ...
Rear upper control arm
Components
Removal
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Remove rear wheel
Disconnect skid control sensor wire (for
2wd) (see page bc-198)
Disconnect rear speed sensor lh (for 4wd)
(see page bc-205)
Rem ...
Front wheel alignment
Adjustment
Inspect tires
Inspect the tires (see page tw-1).
Measure vehicle height
Notice:
Before inspecting the wheel alignment, adjust the
vehicle height to the specification.
Press down on the vehicle several times to stabilize
the suspension, and measure the vehicl ...