Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Ignition switch

Components

Toyota RAV4. Components


Starter relay
On-vehicle inspection Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airb ...

Removal
Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt preten ...

Other materials:

Thermostat
Components Removal Remove no. 1 Engine under cover Drain engine coolant (see page co-6) Remove radiator support opening cover Disconnect no. 2 Radiator hose Remove water inlet Remove the 2 nuts and disconnect the water inlet from the cylinder block. Remove thermostat ...

Only driver door lock / unlock functions do not operate
Description The main body ecu receives lock / unlock switch signals and activates the door lock motor accordingly. Wiring diagram Inspection procedure Perform active test by intelligent tester (door lock) Select the active test, use the intelligent tester to generate a control c ...

Installation
Install generator assembly Confirm that the wire harness of the crankshaft position sensor is secured to the wire harness clamp bracket through the back of the rib of the timing chain cover. Install the generator with the 2 bolts. Torque: 21 n*m (215 kgf*cm, 16 ft.*Lb ...

В© 2011-2026 Copyright www.trav4.net