Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Inspection

  1. Inspect front seat outer belt assembly

Toyota RAV4. Inspect front seat outer belt assembly


Notice:

Do not disassemble the retractor.

  1. Before installing the outer belt, check the elr.
  1. When the inclination of the retractor is 15Рor less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45Ь check that the belt locks.

    If the result is not as specified, replace the outer belt assembly.

Removal
Hint: Use the same procedures for the lh side and rh side. The procedures listed below are for the lh side. Disconnect cable from negative battery terminal Caution: Wait at least 90 ...

Installation
Hint: Use the same procedures for the lh side and rh side. The procedures listed below are for the lh side. A bolt without a torque specification is shown in the standard bolt chart (see pag ...

Other materials:

Towing related terms
â–  GCWR (Gross Combination Weight Rating) The maximum allowable gross combination weight. The gross combination weight is the sum of the total vehicle weight (including the occupants, cargo and any optional equipment installed on the vehicle) and the weight of the trailer being towed (including the ...

Auto lsd indicator light does not come on
Description Refer to the description of "auto lsd indicator light remains on" (see page bc-164). Wiring diagram Refer to the auto lsd indicator light circuit (see page bc-165). Inspection procedure Check can communication system Check if the can communication system dtc is ...

Front occupant classification sensor lh circuit malfunction
Description The front occupant classification sensor lh circuit consists of the occupant classification ecu and the front occupant classification sensor lh. Dtc b1780 is recorded when a malfunction is detected in the front occupant classification sensor lh circuit. Wiring diagram ...

© 2011-2026 Copyright www.trav4.net