Toyota RAV4 (XA40) 2013-2018 Service Manual: Seat belt
- Seat belt warning system
- System description
- How to proceed with troubleshooting
- Operation check
- Problem symptoms table
- Terminals of ecu
- Diagnosis system
- Data list / active test
- On-vehicle inspection
- Front seat inner belt assembly
- Front seat outer belt assembly
- Rear seat inner belt assembly
- Rear seat outer belt assembly
- Rear center seat outer belt assembly
- Child restraint seat tether anchor
Front seat cushion heater
Inspection
Inspect front seat cushion heater
assembly lh
Measure the resistance of the seat cushion heater.
Standard resistance
If the result is not as specified, replace the seat ...
Seat belt warning system
Parts location
System diagram
...
Other materials:
Can communication system
Precaution
Precaution
Turn the ignition switch off before measuring the
resistance of the main wire and the branch wire.
After the ignition switch is turned off, check that the
key reminder warning system and light reminder
warning system are not in operation.
Before measuring th ...
Disassembly
Inspect oil pump assembly (see page ax-218)
Remove clutch drum oil seal ring
Remove the 2 clutch drum oil seal rings.
Remove stator shaft assembly
Using a t30 ''torx'' socket, remove the 11 bolts and
stator shaft. Keep the gears in assembling order.
Inspect clearan ...
Drl relay circuit
Description
The main body ecu controls the daytime running light no. 2 Relay (marking:
drl no.2).
Wiring diagram
Inspection procedure
Inspect daytime running light relay (marking: drl no. 2, Drl no. 3,
Drl no. 4)
Remove the no. 2 Relay, no. 3 Relay and no. 4 Relay from
th ...
