Toyota RAV4 (XA40) 2013-2018 Service Manual: System description
- Driver seat belt warning light
- When the driver seat belt is not fastened with the ignition switch on, the driver seat belt warning light on the combination meter comes on to inform the driver. The center airbag sensor detects the driver seat belt status and sends signals to the combination meter through the can bus line.
- Passenger seat belt warning light
- For automatic air conditioning system: when the passenger seat belt is not fastened with the ignition switch on and the passenger seat occupied, check that the passenger seat belt warning light on the heater control panel display blinks. The combination meter detects the passenger seat belt status and whether the passenger seat is occupied.
- For manual air conditioning system: when the passenger seat belt is not fastened with the ignition switch on and the passenger seat occupied, check that the passenger seat belt warning light on the clock panel blinks. The combination meter detects the passenger seat belt status and whether the passenger seat is occupied.
Seat belt warning system
Parts location
System diagram
...
How to proceed with troubleshooting
Hint:
Use these procedures to troubleshoot the seat belt
warning system.
*: Use the intelligent tester.
Vehicle brought to workshop
Inspect battery voltage
Standard voltage:
...
Other materials:
Door control switch
Inspection
Inspect power window regulator master
switch assembly (door control switch)
Measure the resistance of the door control switch.
Standard resistance
If the result is not as specified, replace the power
window regulator master switch assembly.
Inspect door control s ...
Adjusting the open position
of the back door
(vehicles with power back
door)
The open position of the power
back door can be adjusted.
1. Stop the back door in the
desirable position.
2. Press and hold the power
back door switch on the back
door for approximately 2 seconds.
When the settings are completed,
the buzzer sounds 4 times.
When opening the back door the
next time ...
Communication
Description
The skid control ecu sends signals such as cruise control cancel demand
signals and brake operation
demand from ecm response signals to the ecm when the cruise control system is in
operation.
Inspection procedure
Hint:
This circuit uses can communication. Therefore, if t ...
