Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Installation

  1. Install fan and generator v belt

Toyota RAV4. Install fan and generator v belt


  1. Using sst and 19 mm socket wrench, loosen the vribbed belt tensioner arm clockwise, then install the fan and generator v belt.

Sst 09216-42010

Notice:

  1. Install front suspension member reinforcement rh

  1. Install the reinforcement rh with the 4 bolts.

    Torque: 96 n*m (979 kgf*cm, 71 ft.*Lbf)

  1. Install front fender apron rh

  2. Install front wheel rh

  3. Install radiator support opening cover

Removal
Remove radiator support opening cover Remove front wheel rh Remove front fender apron rh Remove front suspension member reinforcement rh Remove the 4 bolts and reinforcement rh. ...

Valve clearance
Adjustment Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat ...

Other materials:

Fuel pump shut off system
To minimize the risk of fuel leakage when the engine stalls or when an airbag inflates upon collision, the fuel pump shut off system stops the supply of fuel to the engine. Follow the procedure below to restart the engine after the system is activated. Vehicles without a smart key system Tu ...

Curtain shield airbag assembly
Components On-vehicle inspection Check curtain shield airbag assembly (vehicle not involved in collision) Perform a diagnostic system check (see page rs- 49). With the curtain shield airbag assembly installed on the vehicle, perform a visual check. If any of the defects ...

Installation
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. When replacing the clip, heat the clip and body using a heat light. Standard heating temperature Notice: Do not heat the clip and vehicle body excessively. Replace roof dri ...

В© 2011-2026 Copyright www.trav4.net