Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: On-vehicle inspection

  1. Check accelerator pedal rod

Toyota RAV4. Check accelerator pedal rod


  1. Check the voltage.
  1. Connect the intelligent tester to the dlc3.
  2. Turn the ignition switch on
  3. Turn the intelligent tester on.
  4. Select the menu items: diagnosis / enhanced obd ii / data list / all / accel pos #1, accel pos #2.
  5. Operate the accelerator pedal, and then check that the accel pos #1 and accel pos #2 values are within the specifications.

Standard voltage (accel pos #1)


Standard voltage (accel pos #2)


If the result is not as specified, check the accelerator pedal rod, wire harness or ecm.

Accelerator pedal rod
Components ...

Removal
Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt preten ...

Other materials:

Data list / active test
Read data list Hint: Using the intelligent tester's data list allows switch, actuator and other item values to be read without removing any parts. Reading the data list early in troubleshooting is one way to save time. Connect the intelligent tester (with can vim) to the dlc3. Turn ...

Rear occupant classification sensor lh collision detection
Description Dtc b1787 is output when the occupant classification ecu receives a collision detection signal sent by the rear occupant classification sensor lh when an accident occurs. Dtc b1787 is also output when the front seat assembly rh is subjected to a strong impact, even if an actua ...

Center airbag sensor communication stop mode
Description Wiring diagram Inspection procedure Notice: Turn the ignition switch off before measuring the resistances of the main wire and the branch wire. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system ...

В© 2011-2026 Copyright www.trav4.net