Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: On-vehicle inspection

Toyota RAV4. On-vehicle inspection


  1. Check brake fluid level in reservoir

  1. Check the fluid level and add fluid if necessary.

Fluid: sae j1703 or fmvss no. 116 Dot3

Hint:

Add fluid to a level between the reservoir's min and max lines.

Brake fluid
...

Bleeding
Hint: If any work is performed on the brake system or if air in the brake lines is suspected, bleed air from the brake system. Notice: Wash off brake fluid immediately if it comes in contact with ...

Other materials:

Inspection
Inspect oil pump assembly Turn the drive gear with 2 screwdrivers and make sure it rotates smoothly. Notice: Be careful not to damage the oil seal lip. Inspect clearance of oil pump assembly Push the driven gear to one side of the body. Using a feeler gauge, measur ...

Data list / active test (2005/11-2006/01)
Read data list Hint: Using the intelligent tester's data list allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the data list early in troubleshooting is one way to save time. Connect the intelligent tester (with can vim) to the ...

On-vehicle inspection
Check fan and generator v belt Visually check the drive belt for excessive wear, frayed cords, etc. If any defect has been found, replace the drive belt. Hint: Cracks on the rib side of a drive belt are considered acceptable. If the drive belt has chunks missing from the r ...

В© 2011-2026 Copyright www.trav4.net