Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Brake

Oil pump
Components Removal Remove chain sub-assembly Remove the chain (see page em-22). Remove oil pump assembly Remove the 3 bolts, oil pump and gasket. ...

Brake system
...

Other materials:

Tc and cg terminal circuit
Description Connecting terminals tc and cg of the dlc3 causes the skid control ecu to display 2-digit dtcs by flashing the abs warning light. Wiring diagram Inspection procedure Check dlc3 (tc voltage) Turn the ignition switch on. Measure the voltage of the dlc3. Standar ...

Main body ecu communication stop mode
Description Wiring diagram Inspection procedure Notice: Turn the ignition switch off before measuring the resistances of the main wire and the branch wire. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning syste ...

Rear coil spring
Components Removal Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Remove rear wheel Remove skid control sensor wire (for 2wd) (see page bc-198) Remove rear speed sensor lh (for 4wd) (see page bc-205) Disconnect ...

В© 2011-2026 Copyright www.trav4.net