Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Brake system

Brake
...

Precaution
Notice: Take extra care to replace each part properly. Improper installation or repair could affect the performance of the brake system and cause a driving hazard. It is very important to ke ...

Other materials:

When servicing active torque control 4wd vehicles
The active torque control 4wd rav4 is equipped with the 4 wheel drive control system. If incorrect preparations or test procedures are used, the test will not only be unsuccessful, but may be dangerous as well. Caution: Never accelerate or decelerate the vehicle suddenly. Obs ...

Evaporative emission leak detection pump
Dtc summary Hint: The leak detection pump is built into the canister pump module. Description The description can be found in the evap (evaporative emission) system (see page es-335). Inspection procedure Refer to the evap system (see page es-340). Monitor description 5 Hours* afte ...

Check mode procedure
Check mode (signal check) Connect the intelligent tester (with can vim) to the dlc3. Turn the ignition switch on. Select the "signal check", and continue checking with the intelligent tester. Notice: Select the "signal check" from the "dtc check&quo ...

В© 2011-2026 Copyright www.trav4.net