The power outlet can be used for 12 v accessories that run on less than 10 a.
Open the lid.

The power outlets can be used when
The engine switch is in the “acc� or “on� position.
The engine switch is in accessory or ignition on mode.
Notice
To avoid damaging the power outlets
Close the power outlet lids when the power outlets are not in use.
Foreign objects or liquids that enter the power outlets may cause a short circuit.
To prevent the fuse from being blown
Do not use an accessory that uses more than 12 v 10 a.
To prevent battery discharge
Do not use the power outlets longer than necessary when the engine is not running.
Clock
Seat heatersAll-wheel drive lock
switch (awd models)
All-wheel drive lock mode can be used when a large amount of
drive power needs to be applied to all the wheels, such as when
the vehicle gets stuck in mud and you need to free it.
Press the switch.
The torque of the engine is distributed
to the rear wheels to the maximum
extent possible in
ac ...
Removal
Drain engine coolant (see page co-6)
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove air cleaner cap (see page es-41 ...
Lubrication system
On-vehicle inspection
Check engine oil level
Warm up the engine, stop the engine and wait for 5
minutes.
Check that the engine oil level is between the l and
f marks of the oil dipstick.
If low, check for leakage and add oil up to the f
mark.
Notice:
Do not add engine oil a ...