Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Propeller shaft

Power steering ecu
Components Removal Disconnect cable from negative battery terminal Remove instrument panel sub-assembly upper Remove the instrument panel (see page ip-4). Remove power steer ...

Propeller shaft system
Problem symptoms table Hint: Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "suspected ...

Other materials:

Driver side seat belt warning light does not operate
Description When the ignition switch is on, the center airbag sensor transmits front seat inner belt status signals to the combination meter through the can bus line. If the driver seat belt is not fastened, the combination meter blinks the driver side seat belt warning light. If the seat bel ...

Disassembly
Fix differential carrier sub-assembly Fix the rear differential carrier in place with the overhaul attachment. Remove stud bolt Remove the 4 stud bolts from the transmission coupling. Remove differential drain plug Using a 10 mm socket hexagon wrench, remove ...

Reassembly (2006/01- )
Install front drive shaft bearing (for rh) Install the bearing bracket snap ring to the inboard shaft. Using sst and a press, press in the drive shaft bearing to the inboard joint rh. Sst 09527-10011, 09710-04081 Notice: The bearing should be installed completely. Usi ...

В© 2011-2026 Copyright www.trav4.net