Toyota RAV4 (XA40) 2013-2018 Owners Manual: Registering a bluetooth® phone for the first time
To use the hands-free system, it is necessary to register a bluetooth® phone with the system.
Once the phone has been registered, it is possible to use the hands-free system.
For details about registering a bluetooth® device
- Turn the bluetooth® connection setting of your cellular phone on.
- Press the “
” button. - Select “ok” to register a phone.
- Follow the steps in “how to registering a bluetooth® device” from 3.
Registering a bluetooth®
audio player for the
first time
To use the bluetooth® audio, it is necessary to register an audio
player with the system.
Once the player has been registered, it is possible to use the
bluetooth® audio.
For details about r ...
Registering a bluetooth®
device
Bluetooth® compatible phones (hfp) and portable audio players
(avp) can be registered simultaneously. You can register up to 5
bluetooth® devices.
How to register a bluetooth® device
Display ...
Other materials:
Seat heater switch
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove switch base (see page ip-18)
Remove seat he ...
Diagnostic trouble code chart
Hint:
Parameters listed in the chart may be different than your
readings depending on the type of instrument and other
factors.
If any dtcs are displayed during a check mode dtc check,
check the circuit for the dtcs listed in the table below. For
details of each dtc, refer to the page indica ...
Check for intermittent problems
Check for intermittent problems
Hint:
A momentary interruption (open circuit) in the connectors
and/or wire harness between the sensors and ecus can
be detected by using the ecu data list function of an
intelligent tester.
Turn the ignition switch off and connect the
intelligent test ...
