Toyota RAV4 (XA40) 2013-2018 Owners Manual: Registering a bluetooth® device
Bluetooth® compatible phones (hfp) and portable audio players (avp) can be registered simultaneously. You can register up to 5 bluetooth® devices.
How to register a bluetooth® device
- Display the “bluetooth* setup” screen.
*: Bluetooth is a registered trademark of bluetooth sig, inc.
- Select “add”.
- When this screen is displayed, search for the device name displayed on this screen on the screen of your bluetooth® device.
For details about operating the bluetooth® device, see the manual that comes with it.
To cancel the registration, select “cancel”.
- Register the bluetooth® device using your bluetooth® device.
A pin-code is not required for ssp (secure simple pairing) compatible bluetooth® devices. Depending on the type of bluetooth® device being connected, a message confirming registration may be displayed on the bluetooth® device’s screen. Respond and operate the bluetooth® device according to the confirmation message.
- Check that this screen is displayed when registration is complete.
- Select “ok” when the connection status changes from “connecting...” To “connected”.
If an error message is displayed, follow the guidance on the screen to try again.
Registration can be performed from screens other than the “bluetooth* setup” screen.
When registering from the “bluetooth* audio” screen
- Display the “bluetooth* audio” screen
- Select “select device”.
- Follow the steps in “how to registering a bluetooth® device” from 2
*: Bluetooth is a registered trademark of bluetooth sig, inc.
Deleting a bluetooth® device
- Display the “bluetooth* setup” screen.
*: Bluetooth is a registered trademark of bluetooth sig, inc.
- Select “remove”.
- Select the desired device.
- A confirmation message will be displayed, select “yes” to delete the device.
- Check that a confirmation screen is displayed when the operation is complete.
Registering a bluetooth®
phone for the first time
To use the hands-free system, it is necessary to register a
bluetooth® phone with the system.
Once the phone has been registered, it is possible to use the
hands-free system.
For details abou ...
Connecting a bluetooth®
device
Up to 5 bluetooth® devices (phones (hfp) and audio players
(avp)) can be registered.
If more than 1 bluetooth® device has been registered, select
which device to connect to.
Press the “se ...
Other materials:
Armrest
Front (vehicles with slide function)
Slide the console box lid forward
or backward as needed.
Pull the lid forward by holding
the front of the lid.
Rear
Fold down the armrest for use.
Notice
To prevent damage to the armrest
Do not apply too much load on the armrest. ...
Installation
Install rear no. 1 Seat assembly lh (w/o rear no. 2 Seat)
Fully tilt the seatback forward.
Place the seat in the cabin.
Notice:
Be careful not to damage the vehicle body.
Connection procedures of seat to lock cable when
reusing seat:
Using a screwdriver, detach the cla ...
Vc output circuit
Description
The ecm constantly generates 5 v power from the battery voltages supplied to
the +b (batt) terminal to
operate the microprocessor. The ecm also provides this power to the sensors
through the vc output
circuit.
When the vc circuit is short-circuited, the microprocessor in the ...
