Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Tire pressure warning system

Tire pressure warning receiver (w/ antenna)
Components ...

Tc and cg terminal circuit
Description Dtc output mode is set by connecting terminals 13 (tc) and 4 (cg) of the dlc3. The dtcs are indicated by the blinking of the tire pressure warning light. Wiring diagram Hint: Wh ...

Other materials:

Brake switch "B" circuit high
Description The purpose of this circuit is to prevent the engine from stalling while driving in the lock-up condition when the brakes are suddenly applied. When the brake pedal is depressed, this switch sends a signal to the ecm. Then the ecm cancels the operation of the lock-up clutch ...

Disassembly (2005/11-2006/01)
Remove front axle inboard joint boot no. 2 Clamp lh One touch type: Using a screwdriver, remove the no. 2 Inboard joint boot clamp, as shown in the illustration. Claw engagement type: Using needle-nose pliers, remove the no. 2 Inboard joint boot clamp, as shown in t ...

Starter relay
On-vehicle inspection Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove starter relay Remove the starter relay fr ...

В© 2011-2026 Copyright www.trav4.net