Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Tire and wheel

Rear axle hub and bearing
Components On-vehicle inspection Remove rear wheel Disconnect rear drive shaft assembly lh (for 4wd) Disconnect the drive shaft (see page ds-69). Remove rear disc brake cy ...

Tire and wheel system
Inspection Inspect tire Check the tires for wear and proper inflation pressure. Standard cold tire inflation pressure: 220 kpa (2.2 Kgf/cm2, 32 psi) Using a dial indicator, check t ...

Other materials:

Rear occupant classification sensor rh collision detection
Description Dtc b1788 is output when the occupant classification ecu receives a collision detection signal sent by the rear occupant classification sensor rh when an accident occurs. Dtc b1788 is also output when the front seat rh is subjected to a strong impact, even if an actual acci ...

Wheels
If a wheel is bent, cracked or heavily corroded, it should be replaced. Otherwise, the tire may separate from the wheel or cause a loss of handling control. Wheel selection When replacing wheels, care should be taken to ensure that they are equivalent to those removed in load capacity, diameter, rim ...

Light control switch circuit
Description This circuit detects the state of the headlight dimmer switch. Wiring diagram Inspection procedure Read value of intelligent tester (main body ecu) Connect the intelligent tester to the dlc3. Turn the ignition switch on and press the intelligent tester main switch on ...

В© 2011-2026 Copyright www.trav4.net