Toyota RAV4 (XA40) 2013-2018 Service Manual: Tire pressure warning system
- Precaution
- Parts location
- System description
- How to proceed with troubleshooting
- Registration
- Test mode procedure
- Problem symptoms table
- Terminals of ecu
- Diagnosis system
- Data list / active test
- Diagnostic trouble code chart
Tire and wheel system
Inspection
Inspect tire
Check the tires for wear and proper inflation
pressure.
Standard cold tire inflation pressure:
220 kpa (2.2 Kgf/cm2, 32 psi)
Using a dial indicator, check t ...
Precaution
Tire pressure warning system precaution
When the tire pressure warning light turns on,
immediately check the tire pressure of the tire and
adjust it to the specified value. (When the ...
Other materials:
Diagnostic trouble code chart
If a dtc is displayed during the dtc check, check the circuit
listed for the dtc in the table below (refer to the appropriate
page).
Hint:
When the srs warning light remains on and the normal
system code is output, a decrease in the source voltage is
likely to occur. This malfunction is n ...
Removal
Table of bolt, screw and nut
Hint:
All bolts, screws and nuts relevant to installing and
removing the instrument panel are shown along with
their alphabet codes in the table below.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconne ...
Open in stop light switch circuit
Description
The skid control ecu detects the brake operating conditions through a signal
transmitted by the stop light
switch. The skid control ecu incorporates an open circuit detection circuit.
This dtc is set under either of
the following conditions:
An open is detected in the stop lig ...
