Toyota RAV4 (XA40) 2013-2018 Service Manual: When towing active torque control 4wd vehicles
- Use one of the methods shown below to tow the vehicle.
- If the vehicle has trouble in the chassis and drivetrain, use method 1 (flat bed truck).
Notice:
Do not use any towing method other than those shown above.
- For example, the towing methods shown below are dangerous or damage the vehicle, so do not use them.
When servicing active torque control 4wd vehicles
The active torque control 4wd rav4 is equipped
with the 4 wheel drive control system.
If incorrect preparations or test procedures are
used, the test will not only be unsuccessful, but may
...
For vehicles equipped with catalytic converter caution:
If a large amount of unburned gasoline or gasoline
vapors flow into the converter, it may cause
overheating and create a fire hazard. To prevent this,
observe the following precautions.
Use onl ...
Other materials:
Transmission fluid temperature sensor "A" performance
Description
Refer to dtc p0710 (see page ax-46).
Monitor description
This dtc indicates that there is a problem with output from the atf
temperature sensor and that the
sensor itself is defective. The atf temperature sensor converts the atf
temperature to an electrical
resistance v ...
Rear door courtesy switch
Components
Removal
Hint:
Use the same procedures for the rh and lh sides.
The procedures listed below are for the lh side.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal t ...
Downhill assist control operation switch (test mode dtc)
Description
The downhill assist control switch is connected to the skid control ecu in
the abs and traction
actuator.
Dtc c1379/74 can be detected when the downhill assist control switch sends the
downhill assist control
switch signal or test mode ends. Dtc c1379/74 is output only in t ...
