Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Front seat side airbag assembly

Disposal
Hint: When scrapping a vehicle equipped with an srs or disposing of the curtain shield airbag assembly, be sure to deploy the airbag first in accordance with the procedure described below. If any ...

On-vehicle inspection
Check front seat side airbag assembly (vehicle not involved in collision) Perform a diagnostic system check (see page rs- 49). With the front seat side airbag installed on the ve ...

Other materials:

Installation
Replace roof carrier seal Remove the seals. Install new seals as shown in the illustration. Install roof rack leg front lh Install the leg cushion front. Install the roof rack leg front with the 2 screws. Torque: 2.8 To 5.0 N*m (29 to 51 kgf*cm, 25 to 44 in.*Lbf) ...

Fuel pressure pulsation damper
Components Removal Discharge fuel system pressure (see page fu-9) Disconnect cable from negative battery terminal Remove no. 1 Engine cover (see page es-410) Remove air cleaner cap sub-assembly (see page es-411) Disconnect fuel main tube (see page fu-10) Remove fuel pres ...

Intake air temperature sensor gradient too high
Description The intake air temperature (iat) sensor, mounted on the mass air flow (maf) meter, monitors the iat. The iat sensor has a built-in thermistor with a resistance that varies according to the temperature of the intake air. When the iat is low, the resistance of the thermist ...

В© 2011-2026 Copyright www.trav4.net