Toyota RAV4 (XA40) 2013-2018 Service Manual: High pitched horn
Components
Removal
- Remove radiator support opening cover (see page et-4)
- Remove front fender liner lh (see page et-4)
- Remove front fender liner rh (see page et-4)
- Remove front bumper cover (see page et-5)
- Remove high pitched horn
- Disconnect the horn connector.
- Remove the bolt and horn.
Inspection
- Inspect high pitched horn
- Apply battery voltage to the horn and check the operation of the horn.
Ok 
If the result is not as specified, replace the horn.
Installation
- Install high pitched horn
- Place the stay onto the baffle part of the radiator
support upper, and then install the horn with the
bolt.
Torque: 19.5 N*m (199 kgf*cm, 14 ft.*Lbf)
- Connect the horn connector.
- Install front bumper cover (see page et-11)
- Install front fender liner rh (see page et- 12)
- Remove front fender liner lh (see page et- 12)
- Remove radiator support opening cover (see page et-12)
Low pitched horn
Components
Removal
Remove radiator support opening cover
(see page et-4)
Remove front fender liner lh (see page et-4)
Remove front fender liner rh (see page et-4)
Remove front bumper ...
Other materials:
Precaution
Notice:
Perform the reset memory procedures (a/t
initialization) when replacing the automatic transaxle
assembly, engine assembly or ecm (see page ax-18).
Hint:
Reset memory cannot be completed by only reconnecting
the cable to the negative (-) battery terminal.
Caution:
When using compresse ...
Steering angle sensor circuit malfunction
Description
The steering sensor signal is sent to the skid control ecu via the can
communication system. When
there is a malfunction in the can communication system, it is detected by the
steering sensor zero point
malfunction diagnostic function.
Wiring diagram
Inspection proce ...
Wireless charger (if
equipped)
A portable device can be
charged by just placing Qi standard
wireless charge compatible
portable devices according to
the Wireless Power Consortium,
such as smartphones and
mobile batteries, etc., on the
charge area.
This function cannot be used
with portable devices that are
larger than the chargi ...
