Toyota RAV4 (XA40) 2013-2018 Service Manual: Horn

Unlock warning switch

Inspection Inspect unlock warning switch assembly Measure the resistance of the switch. Standard resistance If the result is not as specified, replace the switch assembly. Ecu pow ...

Horn system

Parts location System diagram Problem symptoms table Hint: Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in ...

Other materials:

Removal (2006/01- )
Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove air cleaner case sub-assembly (for 2az-fe) Remove the air clea ...

Reassembly
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Install seat lock release band Install the band with nut. Hint: After installing the band, feed it through the seatback frame hole towards the rear of the vehicle. I ...

Control module communication bus off
Description Inspection procedure The skid control ecu inputs the signals from the ecm, steering angle sensor, and yaw rate and acceleration sensor via can communication system. Check harness and connector (momentary interruption) Using the data list of the intelligent test ...