Toyota RAV4 (XA40) 2013-2018 Owners Manual: Selecting the audio source
Switching between audio sources such as radio and cd are explained in this section.
Changing audio source
- Press the “audio” button to display the audio source selection screen.
If the audio source selection screen is not displayed, press the “audio” button again.
- Select the desired audio source
- Select the desired audio
source then
or
to
reorder.
Using the steering wheel switches to change audio source
The audio source changes as follows each time the “mode/hold” switch is pressed.
Voice settings
This screen is used for setting the voice command guidance
system.
Adjust the voice guidance volume
setting.
Set the voice recognition
prompts “high”, “low” or “off”.
Train vo ...
List screen operation
When a list screen is displayed, use the appropriate buttons to
scroll through the list.
How to scroll
Select to scroll to the next
or previous page.
Appears to the right of
titles, the ...
Other materials:
Air fuel ratio sensor
Components
On-vehicle inspection
Check air fuel ratio compensation system
Connect the intelligent tester to the dlc3.
Turn the ignition switch on.
Select the following menu items: data list / a/fs b1
s1 and o2s b1 s2.
Warm up the a/f sensor with the engine speed at
2,500 ...
Initialization
Zero point calibration
Notice:
Make sure that the front passenger seat is not
occupied before performing the operation.
Hint:
Perform the zero point calibration and sensitivity check if
any of the following conditions apply.
The occupant classification ecu is replaced.
Accessories ( ...
Cup holders
Front
Rear
Pull the armrest down.
Adjusting the size of the cup holder (front passenger’s side)
The adjuster can be removed.
Caution
Items unsuitable for the cup holders
Do not place anything other than cups or aluminum cans in the cup
holders.
Other items may be thrown out ...
