Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Owners Manual: Setup menu

You can adjust the audio system to your desired settings.

Display “setup� screen

Press the “setup� button to display the “setup� screen.

  1. Select to adjust the settings for operation sounds, screen animation, etc.
  2. Select to display the voice settings screen.
  3. Select to adjust the settings for contrast and brightness of the screen.
  4. Select to adjust the settings for registering, removing, connecting and disconnecting bluetooth® devices.
  5. Select to adjust the settings for contact, message settings, etc.
  6. Select to set audio settings.
  7. Select to turn the screen off.
  8. Select to set the vehicle customization
Basic audio operations
Basic audio operations and functions common to each mode are explained in this section. Operating the audio system Press this knob to turn the audio system on and off, and turn it to adj ...

General settings
Settings are available for adjusting the operation sounds, screen animation, etc. ...

Other materials:

Hazard warning switch circuit
Description When the hazard warning signal switch is turned on, the turn signal flasher relay (marking: flsh) in the main body ecu turns on to flash the hazard warning signal lights. Wiring diagram Inspection procedure Perform active test by intelligent tester Connect the intelli ...

Mass air flow circuit range / performance problem
Description Refer to dtc p0100 (see page es-86). Monitor description The maf meter is a sensor that measures the amount of air flowing through the throttle valve. The ecm uses this information to determine the fuel injection time and to provide an appropriate air-fuel ratio. Inside ...

Reassembly
Install sliding roof drive cable Using a screwdriver, slide the sliding roof drive cable sub-assemblies in the direction indicated by the arrow in the illustration to install them. Hint: Tape the screwdriver tip before use. Engage the 2 claws and install the sliding roof ...

© 2011-2026 Copyright www.trav4.net