Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Water pump

Coolant
Replacement Remove no. 1 Engine under cover Drain engine coolant Loosen the radiator drain cock plug. Hint: Collect the coolant in a container and dispose of it according to the regul ...

Removal
Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt preten ...

Other materials:

Vehicle speed signal error (test mode dtc)
Description The tire pressure warning ecu receives a speed signal from the combination meter. This dtc is stored upon entering test mode, and cleared when a vehicle speed signal of 12 mph (20 km/h) is detected for 3 seconds or more. The dtc is output only in test mode. Wiring diagram ...

Driver side seat belt buckle switch circuit malfunction
Description The driver side seat belt buckle switch circuit consists of the center airbag sensor and the front seat inner belt lh. Dtc b1655/37 is recorded when a malfunction is detected in the driver side seat belt buckle switch circuit. Wiring diagram Inspection procedure ...

4Wd control ecu communication stop mode
Description Hint: For vehicle with 4wd only. Wiring diagram Inspection procedure Notice: Turn the ignition switch off before measuring the resistances of the main wire and the branch wire. After the ignition switch is turned off, check that the key reminder warning system ...

В© 2011-2026 Copyright www.trav4.net