Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Owners Manual: Clock

The clock can be adjusted by pressing the buttons.

  1. Adjusts the hours.
  2. Adjusts the minutes.

Toyota RAV4. The clock can be adjusted by pressing the buttons.


The clock is displayed when

The engine switch is in the “acc� or “on� position.

The engine switch is in accessory or ignition on mode.

When disconnecting and reconnecting battery terminals

The clock data will be reset.

Sun visors and vanity mirrors
Sun visors Forward position: flip down. Side position: flip down, unhook, and swing to the side. Side extender (if equipped): place in side position then slide backwards. Vani ...

Power outlets
The power outlet can be used for 12 v accessories that run on less than 10 a. Open the lid. The power outlets can be used when Vehicles without a smart key system The engine switch is in ...

Other materials:

Disassembly (2006/01- )
Remove front axle inboard joint boot no. 2 Clamp One touch type: using a screwdriver, remove the no. 2 Inboard joint boot clamp, as shown in the illustration. Claw engagement type: using needle-nose pliers, remove the no. 2 Inboard joint boot clamp, as shown in the illustra ...

Camshaft position "A"
Dtc P0011 Camshaft position "a" - timing over-advanced or system performance (bank 1) Dtc  P0012 Camshaft position "a" - timing over-retarded (bank 1) Description The vvt system includes the ecm, oil control valve (ocv) and vvt controller. The ecm sends a target du ...

Dtc check / clear
Check dtc Connect the intelligent tester (with can vim) to the dlc3. Turn the ignition switch on and turn the intelligent tester on. Read the dtc by following the prompts on the tester screen. Hint: Refer to the intelligent tester operator's manual for further details. ...

© 2011-2026 Copyright www.trav4.net