Toyota RAV4 (XA40) 2013-2018 Owners Manual: Displaying a bluetooth® device details
You can confirm and change the registered device details.
Bluetooth® device registration status
- Display the “bluetooth* setup” screen.
*: Bluetooth is a registered trademark of bluetooth sig, inc.
- Select the device.
- Select “device info”.
- Following screen is displayed:
- Device name
- Change connection method
- Bluetooth® address
- Display your telephone number
The number may not be displayed depending on the model of phone.
- Compatibility profile of the device
- Restore default settings
Changing connection method
- Select “connect audio player from”.
- Select “vehicle” or “device”.
“Vehicle”: connect the audio system to the portable audio player.
“Device”: connect the portable audio player to the audio system
Connecting a bluetooth®
device
Up to 5 bluetooth® devices (phones (hfp) and audio players
(avp)) can be registered.
If more than 1 bluetooth® device has been registered, select
which device to connect to.
Press the “se ...
Detailed bluetooth®
system settings
You can confirm and change the detailed bluetooth® settings.
How to check and change detailed bluetooth® settings
Display the “bluetooth* setup” screen.
Select “system settings”.
Th ...
Other materials:
Rear window wiper and
washer
The rear window wiper and
washer can be used by
operating the lever.
NOTICE
■When the rear window is dry
Do not use the wiper, as it may
damage the rear window.
Operating the wiper lever
Operating the switch
operates the rear wiper as follows:
*1 or
*2 Off
*1 or
*2 Intermittent
operation
...
Input speed sensor circuit no signal
Description
This sensor detects the rotation speed of the turbine, which shows the input
revolution of the transaxle. By
comparing the input speed signal (nt) with the counter gear speed sensor signal
(nc), the ecm detects
the shift timing of the gears and controls the engine torque and ...
For vehicles equipped with mobile communication systems
Install the antenna as far away from the ecu and
sensors of the vehicle electronic systems as
possible.
Install an antenna feeder at least 20 cm (7.87 In.)
Away from the ecu and sensors of the vehicle
electronic systems. For details about ecu and
sensor locations, refer to the sec ...
