Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: On-vehicle inspection

  1. Check front seat side airbag assembly (vehicle not involved in collision)

Toyota RAV4. Check front seat side airbag assembly (vehicle not involved in collision)


  1. Perform a diagnostic system check (see page rs- 49).
  2. With the front seat side airbag installed on the vehicle, perform a visual check. If any of the defects mentioned below are present, replace the front seat with a new one: cuts, minute cracks or marked discoloration on the front seat side airbag or around the front seat side airbag.
  1. Check front seat side airbag assembly (vehicle involved in collision and airbag has not deployed)

Toyota RAV4. Check front seat side airbag assembly (vehicle involved in collision and airbag has not deployed)


  1. Perform a diagnostic system check (see page rs- 49).
  2. With the front seat side airbag removed from the vehicle, perform a visual check.

If any of the defects mentioned above are present, replace the front seat with a new one.

Caution:

For removal and installation procedures of the front seat side airbag, be sure to follow the correct procedure.

Front seat side airbag assembly
...

Disposal
Hint: When scrapping a vehicle equipped with srs or disposing of the front seat side airbag, be sure to deploy the airbag first in accordance with the procedure described below. If any abnormality ...

Other materials:

How to proceed with troubleshooting
Hint: Use these procedures to troubleshoot the lighting system. *: Use the intelligent tester. Vehicle brought to workshop Inspect battery voltage Standard voltage: 11 to 14 v If the voltage is below 11 v, recharge or replace the battery before proceeding. Refer to pr ...

Stop & Start system
The Stop & Start system stops and starts the engine according to brake pedal or shift lever operation when the vehicle is stopped, such as at a stoplight, intersection, etc., in order to improve fuel economy and reduce noise pollution caused by the engine idling. Stop & Start system operatio ...

Terminals of ecu
Check combination meter assembly Measure the voltage and resistance of the connector. Check instrument panel junction block (main body ecu) Measure the voltage and resistance of the connectors. ...

В© 2011-2026 Copyright www.trav4.net