Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual

Toyota RAV4 (XA40) 2013-2018 Service Manual

Srs airbag instructions for canadian owners (in french)
The following is a french explanation of srs airbag instructions extracted from the srs airbag section in this manual. See the srs airbag section for more detailed srs airbag instructions in englis ...

Introduction
...

Other materials:

Short in driver side squib circuit
Description The driver side squib circuit consists of the center airbag sensor, the spiral cable and the steering pad. The circuit instructs the srs to deploy when the deployment conditions are met. These dtcs are recorded when a malfunction is detected in the driver side squib circui ...

Removal (2005/11-2006/01)
Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove roof headlining assembly Remove the roof headlining (see page ir ...

Reassembly
Install piston Using a small screwdriver, install a new snap ring onto one end of the piston pin hole. Hint: Make sure that the end gap of the snap ring is not aligned with the pin hole cutout portion of the piston. Gradually heat the piston up to 80 to 90°c (176 to 194°f ...

© 2011-2026 Copyright www.trav4.net