Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Repair instruction

Identification information
Vehicle identification and serial numbers Vehicle identification number The vehicle identification number is stamped on the vehicle identification number plate and on the certification l ...

Precaution
...

Other materials:

Rear axle hub bolt
Components Replacement Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Remove rear wheel Remove rear disc brake cylinder assembly lh (see page br-55) Remove rear disc (see page br-57) Remove rear axle hub bolt ...

Inspection
Inspect cylinder block for warpage Using a precision straightedge and feeler gauge, measure the warpage of the surface that is in contact with the cylinder head gasket. Maximum warpage: 0.05 Mm (0.0020 In.) If the warpage is greater than the maximum, replace the cylinder block ...

Sleep operation failure of occupant classification ecu
Description During sleep mode, the occupant classification ecu reads the condition of each sensor while the ignition switch is off. In this mode, if the occupant classification ecu detects an internal malfunction, dtc b1796 is output. Inspection procedure Check for dtc T ...

В© 2011-2026 Copyright www.trav4.net