Toyota RAV4 (XA40) 2013-2018 Service Manual: Front seat inner belt assembly

Front passenger side seat belt warning light malfunction

Description When the ignition switch is on, the center airbag sensor transmits front seat inner belt status signals to the combination meter through the can bus line. If the front passenger seat b ...

Removal

Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt preten ...

Other materials:

Only rear door rh lock / unlock functions do not operate
Description The main body ecu receives lock / unlock switch signals and activates the door lock motor accordingly. Wiring diagram Inspection procedure Inspect rear door with motor lock assembly rh Apply the battery voltage to the door lock motor and check the operation of th ...

Vehicle speed signal error (test mode dtc)
Description The tire pressure warning ecu receives a speed signal from the combination meter. This dtc is stored upon entering test mode, and cleared when a vehicle speed signal of 12 mph (20 km/h) is detected for 3 seconds or more. The dtc is output only in test mode. Wiring diagram ...

Rear bumper
Components Removal Remove rear bumper cover Remove the 9 screws and 7 clips. Put protective tape under the quarter panel. Detach the 12 claws and remove the bumper cover. Remove rear bumper protector Hint: When removing the bumper protector, heat the bumper prot ...