Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Front seatback heater

Inspection

Toyota RAV4. Front seatback heater


  1. Inspect front seatback heater assembly lh

  1. Measure the resistance of the seatback heater.

Standard resistance


If the result is not as specified, replace the seatback heater assembly

  1. Inspect front seatback heater assembly rh

Hint:

Use the same procedures described for the lh side.

Seat heater switch
Components Removal Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent ai ...

Front seat cushion heater
Inspection Inspect front seat cushion heater assembly lh Measure the resistance of the seat cushion heater. Standard resistance If the result is not as specified, replace the seat ...

Other materials:

How to proceed with troubleshooting
Hint: Use these procedures to troubleshoot the seat belt warning system. *: Use the intelligent tester. Vehicle brought to workshop Inspect battery voltage Standard voltage: 11 to 14 v If the voltage is below 11 v, recharge or replace the battery before proceeding. ...

Rear seats
Reclining adjustments and folding the seatbacks can be done with lever operation. Adjustment procedure Pull the seatback angle adjustment lever A, and adjust the seatback angle. WARNING â– When operating the seatback Observe the following precautions. Failure to do so may cause death or serious in ...

Open in pump motor circuit
Description The motor relay drives the pump motor based on a signal from the skid control ecu. Wiring diagram Refer to dtc c0273/13, c0274/14, c1361/91 (see page bc-79). Inspection procedure Perform active test by intelligent tester (motor relay) Select the active test, gener ...

© 2011-2026 Copyright www.trav4.net