Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Door lock

Installation
Install rear differential support Install the differential support to the differential carrier with the 4 bolts. Torque: 98 n*m (999 kgf*cm, 72 ft.*Lbf) Install rear differential ...

Power door lock control system
...

Other materials:

Terminals of ecm
Check ecm Measure the voltage of the ecm connector. Hint: Each ecm terminal's standard voltage is shown in the table below. In the table, first follow the information under "condition". Look under "symbols (terminal no.)" For the terminals to be inspected. ...

How to proceed with troubleshooting
Hint: Use these procedures to troubleshoot the sliding roof system. *: Use the intelligent tester. Vehicle brought to workshop Inspect battery voltage Standard voltage: 11 to 14 v If the voltage is below 11 v, recharge or replace the battery before proceeding. Inspe ...

Switch failure
Description This dtc is output when the sliding roof drive gear (sliding roof ecu) detects that the slide open or tilt up switch in the overhead junction block is stuck for 30 seconds or more. Wiring diagram Refer to dtc b2341 (see page rf-11). Inspection procedure Read value of i ...

В© 2011-2026 Copyright www.trav4.net