Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Axle

Rear drive shaft assembly
Components Removal Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Disconnect cable from negative battery terminal Ca ...

Axle system
Problem symptoms table Hint: Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "suspected ...

Other materials:

Indications on multi-information display
Vehicles with 7-inch display LTA indicator The illumination condition of the indicator informs the driver of the system operation status. Illuminated in white: LTA system is operating. Illuminated in green: Steering wheel assistance of the steering assist function or lane centering function is ...

Short to b+ in can bus line
Description There may be a short circuit between the can bus line and +b when there is resistance between terminals 6 (canh) and 16 (bat) or terminals 14 (canl) and 16 (bat) of the dlc3. Wiring diagram Inspection procedure Notice: Turn the ignition switch off before measuring ...

Ts and cg terminal circuit
Description If the vehicle is stationary during sensor check mode, speed sensor malfunctions cannot be detected. The vehicle must be driven for speed sensor malfunctions to be detected. Hint: Change to sensor check mode by connecting terminals tc and cg of the dlc3, and turning the ignitio ...

В© 2011-2026 Copyright www.trav4.net