Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Maintenance

Rear power outlet socket
Components Removal Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to preven ...

Outside vehicle
General maintenance Performing the following maintenance checks on the vehicle is the owner's responsibility. The owner may perform the maintenance or take the vehicle to a service center. Check t ...

Other materials:

Open in stop light switch circuit
Description The skid control ecu detects the brake operating conditions through a signal transmitted by the stop light switch. The skid control ecu incorporates an open circuit detection circuit. This dtc is set under either of the following conditions: An open is detected in the stop lig ...

All-wheel drive lock switch (awd models)
All-wheel drive lock mode can be used when a large amount of drive power needs to be applied to all the wheels, such as when the vehicle gets stuck in mud and you need to free it. Press the switch. The torque of the engine is distributed to the rear wheels to the maximum extent possible in ac ...

Dtc check / clear
Check dtc Connect the intelligent tester (with can vim) to the dlc3. Turn the ignition switch on and turn the intelligent tester on. Read the dtc by following the prompts on the tester screen. Hint: Refer to the intelligent tester operator's manual for further details. ...

В© 2011-2026 Copyright www.trav4.net