Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: General maintenance (2006/01- )

  1. General notes

  1. Windshield washer fluid

  1. Check that there is sufficient fluid in the tank.
  1. Engine coolant level

  1. Check that the coolant level is between the "full" and "low" lines on the see-through reservoir.
  1. Radiator and hoses

  1. Check that the front of the radiator is clean and not blocked by leaves, dirt or bugs.
  2. Check the hoses for cracks, kinks, rot or loose connections.
  1. Battery electrolyte level

  1. Check that the electrolyte level of all the battery cells is between the upper and lower level lines on the case.

Hint:

If the electrolyte level is difficult to see, lightly shake the vehicle.

  1. Brake fluid level

  1. Check that the brake fluid levels are near the upper level lines on the see-through reservoirs.
  1. Engine drive belt

  1. Check the drive belt for fraying, cracks, wear or oiliness.
  1. Engine oil level

  1. Check the level on the dipstick with the engine stopped.
  1. Automatic transaxle fluid level


  2. Exhaust system

  1. Check for unusual exhaust sounds or abnormal exhaust fumes. Inspect the cause and repair it.
General maintenance (2005/11-2006/01)
General notes Maintenance requirements vary depending on the country. Check the maintenance schedule in the owner's manual supplement. Following the maintenance schedule is mandatory. ...

Engine
...

Other materials:

Communication
Description The skid control ecu sends signals such as cruise control cancel demand signals and brake operation demand from ecm response signals to the ecm when the cruise control system is in operation. Inspection procedure Hint: This circuit uses can communication. Therefore, if t ...

Communication malfunction no. 1
Description This dtc is output when a communication error occurs between the transponder key amplifier and transponder key ecu. Some possible reasons for the communication error are: 1) 2 or more ignition keys are positioned too close together, or 2) noise is occurring in the communicatio ...

Terminals of ecu
Check combination meter assembly Measure the voltage and resistance of the connector. Check instrument panel junction block (main body ecu) Measure the voltage and resistance of the connectors. ...

В© 2011-2026 Copyright www.trav4.net