Toyota RAV4 (XA40) 2013-2018 Service Manual: Timing chain

Valve clearance

Adjustment Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat ...

Components

...

Other materials:

Ecm power source circuit
Description When the ignition switch is turned on, the battery voltage is applied to the igsw of the ecm. The output signal from the mrel terminal of the ecm causes a current to flow to the coil, closing the contacts of the integration relay (efi main relay) and supplying power to either term ...

Installation
Install water pump assembly Remove any old seal packing material from the contact surface. Apply a continuous line of seal packing as shown in the illustration. Seal packing: toyota genuine seal parking black, three bond 1207b or equivalent Standard seal diameter: 2.2 To 2. ...

Light control switch circuit
Description This circuit detects the state of the headlight dimmer switch. Wiring diagram Inspection procedure Read value of intelligent tester (main body ecu) Connect the intelligent tester to the dlc3. Turn the ignition switch on and press the intelligent tester main switch on ...